![]() ![]() Step5: Assign IP address/Subnet Mask of the Management Interface ( Not TFTP Server, Step4: Initialize Management Interface switch: mgmt_init Step 3: Initialize flash: switch: flash_init Step 2: Connect your Labtop/PC (or TFTP Server) to the back port of the Switch (10/100TX, next to console/serial port) via Straight cable. ![]() This recovery procedure requires that you have physical access to the switch. This procedure uses boot loader commands and TFTP to recover from a corrupted or wrong image file. Power-on self-test (POST), and there is no connectivity. In all of these cases, the switch does not pass the Upgrade, by downloading the wrong file to the switch, and by deleting Switch software can be corrupted during an How-To Recover a Cisco Switch from Boot Loader 3560/3750įebru/ Balaji Bandi / 0 Comments Recovering from a Software Failure Method 1: Transferring IOS image using TFTP ![]()
0 Comments
Leave a Reply. |